1. Application for Traditional Thickness of Liquid in New Buildings

Table 1 Application Thicknesses of styronit in buildings without plastered

 

• In buildings which have been plastered both in inner and outer surfaces, top thicknesses are applied with the thickness levels explained with thin styronit. (Table 2)
• Thicknesses have been defined by regarding minimum heat conductivity resistances for one piece isolation coating found in TSE 825 heat regulations before the year 2000.(Table2)
•  
• Plaster + Exterior Thermal Sheathing application loads ~ 130 kg/m2 wall however in a building plated with styronit this value is just  ~ 7 kg/m2  wall

 

 

2. Application (on paint) in Inhabited Buildings

BIO-thermal sheathing is applied inside of the building.

• Minimum Suggested Thicknesses;              

Table. 2 Application Thicknesses of styronit for inhabited buildings according to Temperature zones

Application done from inside and in 1 cm thickness, in practical, provides heat performance till 1 cm thick felt wool.  Styronit applied by given thicknesses- provides 10C temperature increse and and saves heat till 60%.

Exterior Application on Paint;

Table 3. Exterior styronit Application Thicknesses according to Heat Zones in Inhabited Buildings

 

Figure.1  Painted Building Exterior Side Application

Plaster panels are sticked to the building surface horizantally with 50 cm space between each one. (Figure 1)
2-3 mm thin lining styronit is applied. After absorbance styronit rough filling is practised under described plaster panel thicknesses. It is concluded with 3-4 mm styronit thin and 2 mm styronit to the last layer. 

• Before application, plaster panels must be sticked to the building surface. (On the building wall, horizantally with 50 cm space between each one.)
• 2-3 mm thin lining styronit is applied on the paint. After absorbance rough filling is practised under described plaster panel thicknesses and the whole application is concluded with 3-4 mm thin styronit. (Figure 1)